nC® ProTect 4600 P&T Foodgrade Sealant
nC® Protect 4600 FG Sealant P&T is a transparent coating developed to protect materials from abrasion, absorption, corrosion and fouling. It can be applied on uncoated chalybeate and non-chalybeate metals, (U)HDPE, PMMA, epoxy- and polyuretane coatings and polyestercoatings. Furthermore on galvanized metals and powdercoated surfaces and glass. nC® Protect 4600 Sealant is approved for foodcontact according to FDA specifications.
nC® Protect 4600 FG Sealant P&T bonds chemically into materials and their surfaces. It forms a matrix inside the material. The surface develops a very flexible ultra-thin, impermeable, gloss-like finish. Consequently, this finish is very suitable to protect against negative chemical and environmental influences. Dirt, dust, grease and organic pollution cannot adhere to the treated surface. Cleaning of the surface is seldomly required, and if so, can be done by hosing down or pressured air without the need of chemicals or soap.
nC® Protect 4600 FG Sealant P&T is capable of re-installing the colour of chalked or slightly bleached surfaces. Revitalising the colours of rolling doors, weathered car paints, yachts, bumpers or building facades is very easy and effective with this sealant.
nC® Protect 4600 FG Sealant P&T is user ready and can be applied by brush, roller, cloth or airgun (HVLP). It has an extreme good spread-rate of 80m² per liter. The Sealant will protect the material it is applied on for up to 15 years.
The product is dry to touch within 2 up to 3 hours. As nanotechnology is about bonding into surfaces and matrices of nanoparticles need to be built up after application, the coating reaches full insulating ability AFTER a cure time of approximately 3 to 5 days, which is dependent upon environmental variables, humidity, and thickness of coat used. Test of maximum performance should be performed after full cure. Benefits will typically begin to be seen approximately 24 hours after application, and will continue to improve as the cure time completes. Cure time won’t interfere with normal operations, you can start using the treated materials after 24 hours and continue to use your equipment as usual while the product cures.
nC Industrial © 2020 - All Rights Reserved